You’ll likely need your fish tape for this again, as well as your power drill to drill holes through walls or ceilings. Once you have all of the cable runs located where each camera will be, it’s now time to route all of those cables to the DVR box. If you’re using ethernet cable, you might have to crimp your own connectors on if they’re not already installed. Next unwrap and remove the fish tape, and your cable will be ready to hook up to your camera when you’re ready to install it. RELATED: How to Crimp Your Own Custom Ethernet Cables of Any Length This job is a whole lot easier with a friend helping you. Once the fish tape extends far enough into the attic for easier access, tape the end of the cable to the fish tape and pull on the fish tape from the outside to thread the cable through the hole you drilled. Since the cameras directly plug into the DVR box, this means that if you install a camera by your back patio and the DVR box is upstairs in your home office, you’ll need to route the camera’s cable through your house in order to connect it to the DVR box, which can get a bit complicated, depending on how your house is built how exactly you plan to route the cable. If you have an analog system, I highly recommend skipping the BNC cable and getting special adapters called baluns, which allow you to use Ethernet cables-they’re a lot easier to install and more modern overall. RELATED: How Do Night Vision Cameras Work?Īll of the cameras connect directly to the DVR box, either using BNC cable for analog camera systems, or ethernet cable for digital systems. Pretty much every system consists of a set of cameras and a DVR box that serves as the user interface for managing the entire system, as well as storing all of the video footage that gets recorded. Before you dive deep into installing a wired security camera system, you first have to understand how everything is connected.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |